Icon Logo Gun Mart

Jack Pyke Resetting 5-Disc Spinner Target

Jack Pyke Resetting 5-Disc Spinner Target

story continues below...

The Resetting 5-Target Spinner measures 11 ½” high X 10 ¼” wide with the top re-set spinner head protruding 3” above the top of the open oblong antirust treated metal frame.  It also has two metal stabilising bars so it can be used on hard ground or better still pushed vertically into the ground. The stabilising bars articulate yet are held captive on a slightly wider protrusion on the inside of the framework, this allows a full 2 ¾” of the outer frames lower prongs to be fully pushed into the ground while the bars can be turned 90-degree to the rear to add further stability.

Four metal target discs hang down from a crossbar in the usual manner and have 40mm kill-zone hi-viz orange stickers applied to the front. When hit they freely swing back and over to rest on a crossbar attached to the upper re-set spinner – obviously the head of this is of the same diameter as the other four. When all the lower spinners are hit and rested on the upper bar, shoot the top spinner head and it will swing far enough back to allow the others to reset to their original position. Simple but addictive fun!

  • Jack Pyke Resetting 5-Disc Spinner Target - image {image:count}

    click on image to enlarge

  • Jack Pyke Resetting 5-Disc Spinner Target - image {image:count}

    click on image to enlarge

  • Jack Pyke Resetting 5-Disc Spinner Target - image {image:count}

    click on image to enlarge

Arrow